FF2NX Question

Hi,

I noticed that a file converted from FF2 using "extended" fields all had the
decimal places set at "2" after the conversion.

In this particular table that is correct.

Does the FF2NX converter adjust the decimal places to the maximum used in
the original FF2 file. In which case it could produce problems at a later
date.

Regards,

Roy

>Does the FF2NX converter adjust the decimal places to the maximum used in
>the original FF2 file. In which case it could produce problems at a later
>date.

It uses the setting of the decimal places as used in FF. But I know no
Delphi control which uses this property as it only a preference for
the value display, and Delphi controls normally use EditMasks which
includes the definition of decimal places used.
Regards from Germany

Franz-Leo Chomse [NexusDB Expert]
franz.leo.chomse@ndx.nexusdb_x.com (please remove "_x" to reply)